Flowserve DataFlo P Smart Positioner User Manual download pdf

DataFlo P

Smart Positioner

Functions

FCD WCAIM2060-00 (Part 08023)

1. Remove cover and apply appropriate voltage to terminals 1 (neutral

or negative) and 2 (hot or positive).

2. Connect input source to terminals 10 (-) and 11 (+) and 12 (if

applicable).

3. The display should be ﬂashing between “Pos” and a number

between 0 and 100.

4. Simultaneously press and hold the “SEL” and “DN” keys for three

seconds. “CAL” will be displayed for two seconds and the security

code will be checked. If the required security code is not zero

(“0000”), the display will begin alternating between “CodE” and

“0000.”

NOTE: If the required code is zero, it will not need to be entered, i.e.,

it will be bypassed and display will automatically ﬂash “SEtL.” Skip

to paragraph 8.

5. Enter the security code, if necessary, as follows. (If the code is

forgotten, the special number 4800 can be used to gain entry.)

6. Quick tap “SEL” key once. First 0 will ﬂash. Quick tap “UP” key until

you reach code number. Quick tap the “DN” key once. The second 0

will ﬂash. Quick tap “UP” key until the next code number is reached.

Continue this procedure as needed for the remaining code numbers.

Quick tap “SEL” to accept code.

7. The display now ﬂashes between “SEtL” and a value.

8. Simultaneously press and release “SEL” and “UP” keys, then adjust

input signal to lower input value, e.g., 4 mA. Quick tap “SEL” to lock

in value.

9. Quick tap “DN” key. Display will ﬂash “SEtU” and a value.

Worcester Actuation Systems

1 2

DataFlo P Smart PositionerFunctionsFCD WCAIM2060-00 (Part 08023)1. Remove cover and apply appropriate voltage to terminals 1 (neutral or negative)

10. Simultaneously press and release “SEL” and “UP” keys, then adjust input signal to higher input value, e.g., 20 mA. Quick tap “SEL” to lock in val

Flowserve DataFlo P Smart Positioner User Manual