Flowserve PLEUGER User Manual download pdf (Page 29)

PLEUGER STANDARD USER INSTRUCTIONS ENGLISH 71569293 01-13

Page 29 of 40 flowserve.com

f) The screw plug [6780] and one of the two vent

valves [B6523] mentioned above must be taken

from the accessory pack supplied with the motor.

(See section 6.5.9, Accessory pack “Z”.) For the

second vent valve [B6523], use the one that has

been screwed out, as described in b) above.

g) All seals [4510] for replacement are contained in

accessory pack “Z”.

After installing the vent valves, the

motor must not be rotated or positioned vertically.

h) Top up the motor again in its installed position

until the liquid escaping from the vent valve

[B6523] contains no bubbles.

i) Pull the filling pump hose off the filling nipple [2]

and screw out the filling nipple (if the filling has

been carried out with a filling pump) and refit the

screw plug [0168] into the filling valve [B6514]

together with the seal ring [4510].

6.6.10 Motors with header tank for horizontal

installation

(See figure 6-10.)

Motors for this type of installation must be

specially equipped.

a) Put the motor horizontally with the vent valve

[B6523] at the top. Screw out the vent valve

[B6523] and replace it with a screw plug [6780]

from the accessory pack (see section 6.5.9,

Accessory pack “Z”.)

b) Rotate the motor so that the carriers located on

the stator housing are at the top. Remove the

screw plugs [6780] from the carriers, and screw

the pipe connectors [2 and 3] into the threaded

holes (M16 x 1.5).

c) Fit the pipes “V” into the connectors [2 and 3] up

to the points marked "Y" and close the pipe on

the end.

d) Rotate the motor so that the filling valve [B6514]

is at the top. Screw out the filling valve [B6514]

and screw a pipe connector [4] into the threaded

hole (R ⅜ in. or R ¾ in.).

e) Fit the pipes/hoses [“F”] into the connector [4] up

to the points marked “X” and close the pipe on

the end.

f) Install the motor horizontally and lay further pipes

up to the header tank [1].

Figure 6-9A

Figure 6-9B

Figure 6-10

1 2 ... 24 25 26 27 28 29 30 31 32 33 34 ... 39 40

Comments to this Manuals

No comments

Flowserve PLEUGER User Manual Page 29

Comments to this Manuals

Related products and manuals for Pumps Flowserve PLEUGER